Further insights into the mechanics of multi seam subsidence from Ashton Underground MinePublished Feb, 2021Ashton Underground Mine (Ashton) is an underground longwall mine located northwest of Singleton in the Hunter Valley of NSW. The mine has so far extracted longwall panels in three seams with mining in a fourth seam planned and each seam progressively deeper than the last. The mining geometry in each of the seams is regular, parallel and either offset or stacked relative to the panels in the seams above. A subsidence line crossing all panels in each seam has been regularly surveyed in three dimensions since the commencement of mining. The high quality data set available from this line provides insight into the mechanics of ground behaviour in a multi-seam environment. This paper presents an update of the observations and interpretation presented in Mills and Wilson (2017) for mining in two seams with the inclusion of results from mining in a third seam.
Observations of the characteristics of multi-seam subsidence continue to indicate that although subsidence movements above multi-seam mining are more complex than single seam mining, these movements are nevertheless regular and predictable. In an offset geometry, remote from pillar and goaf edges, tilt and strain levels are similar or lower than single seam levels, despite the greater vertical subsidence, due to the general softening or reduction in shear stiffness of the overburden with each episode of subsidence. At stacked and undercut goaf edges, transient tilts and strains are significantly elevated.
Cumulative vertical subsidence after longwall mining in three seams has now reached 5.8m with incremental vertical subsidence increasing as a percentage of incremental mining height with each episode of subsidence. Latent subsidence from near stacked goaf edges is recovered when mining in the seam below. A site-specific methodology developed to forecast subsidence behaviour is allowing measured subsidence effects to be estimated reliably.
Insights into the mechanics of multi seam subsidence from Ashton Underground Mine - Ken Mills - Steve WilsonPublished Feb, 2017Examples of subsidence monitoring of multi-seam mining in Australian conditions are relatively limited compared to the extensive database of monitoring from single seam mining. The subsidence monitoring data now available from the mining of longwall panels in two seams at the Ashton Underground Mine (Ashton) provides an opportunity to significantly advance the understanding of subsidence behaviour in response to multi-seam mining in a regular offset geometry. This paper presents an analysis and interpretation of the multi-seam subsidence monitoring data from the first five panels in the second seam at the Ashton Underground Mine. The methods used to estimate subsidence effects for the planned third seam of mining are also presented.
Observations of the characteristics of multi-seam subsidence indicate that although more complex than single seam mining, the subsidence movements are regular and reasonably predictable. Movements are constrained within the general footprint of the active panel. They are however sensitive to the relative panel geometries in each seam and to the direction of mining. In an offset geometry, tilt and strain levels are observed to remain at single seam levels despite the greater vertical displacement. At stacked goaf edges tilt and strain levels are up to four times greater. Latent subsidence recovered from the overlying seam has been identified as a key contributor to the subsidence outcomes. Some conventional single seam concepts such as angle of draw and subcritical/supercritical behaviour are less meaningful in a multi-seam environment. Insights-into-the-mechanics-of-multi-seam-subsidence-from-Ashton-Underground-Mine-K.Mills-S.Wilson-2017.pdf2.5 MB